The stainless steel filter is classified as a flammable item, so be careful in the process of transportation, equipment and work, and not close to the fire source. To ensure that the equipment can play the best effect, it should be used in a ventilated and monotonous environment. Before use, check whether the water inlet pipe and drain pipe of the equipment are in good contact. If there is a leakage, it is very likely to cause damage to the equipment. Before the equipment, the motor must be checked, and a fuse with the correct capacity must be used.To get more news about stainless steel filter wire mesh, you can visit resenwiremesh.com official website.

Regarding the maintenance of the stainless steel filter, it is necessary to plan according to the actual working conditions and customer requirements. The operating environment must not contain corrosive substances. In order to ensure that the equipment can exert normal power, it must be used under suitable temperature and humidity. Assuming it is used in areas where the air is relatively turbid, you can consider adding a layer of filter in between.

If there are any problems in the process of application, please contact professional repair personnel to repair them in time, and do not disassemble it privately. In the process of use, do not disassemble the components at will. If repairs are required, the power supply should be blocked in time to prevent unnecessary injuries. Stainless steel filter mesh The surface of the stainless steel wire mesh has rainbow patterns, which is caused by excessive use of detergent or oil. It can be washed away with a warm water detergent when scrubbing.

Rust caused by dirt on the surface of stainless steel can be scrubbed with 10% nitric acid or abrasive scrubbing agent, or with special scrubbing chemicals. As long as we use the correct maintenance methods, we can extend the service life of stainless steel and maintain its clean, bright and beautiful air volume. In the passive film on the stainless steel surface, the corrosion-resistant parts are weak, which form a pitting reaction due to the self-excited reaction, resulting in the formation of small holes. In addition, the chloride ion is close to form a strong corrosive solution, which accelerates the rate of the corrosion reaction. The stainless steel filter screen and the intergranular corrosion cracking inside the stainless steel, all of which damage the passivation film on the surface of the stainless steel.